Zeck Audio STAC Force180 Guide d'installation télécharger pdf (Page 34)

Rev. 1.00 12-02-13 34/41

First appeared in build series: 2012-07-18

Mode: pvc ppp

Command

Purpose

Step 1

[node](pvc)[vpi/vci]# pppoe

Enters PPPoE configuration mode for

this PVC.

Step 2

node(pppoe)# session <Session-Name>

Defines a PPPoE session.

Step 3

(Optional)

node(session)[name]#service <Service-

Name>

Defines the tag „Service-Name‟ to be

supplied with Active Discovery in order

to identify the desired remote peer

(check whether the remote peer

supports this feature)

Step 4

(Optional)

node(session)[name]#access-

concentrator <AC-Name>

The Active Discovery only accepts the

PPPoE session if the remote peer

provides tag „AC-Name‟ with its Active

Discovery Offer as specified. This allows

to identify the desired remote peer

Step 5

[node](pvc)[vpi/vci]# [no] bind interface

<name> [router]

or

node](pvc)[vpi/vci]# [no] bind subscriber

<name>

Binds the PPPoE session directly to the

IP interface name in case no

authentication is required.

Binds the PPPoE session to the PPP

subscriber name in case authentication

is required.

Step 6

(Optional)

[node](pvc)[vpi/vci]# [no] use profile ppp

<Profile-Name>

Assigns a PPP profile other than the

default. (default: default)

Step 7

[node](pvc)[vpi/vci]# [no] shutdown

Enables or disables PPPoA session.

(default: disabled)

Setting up permanent virtual circuits (PVC) for IPoA

First appeared in build series: 2012-07-18

Mode: port dsl

Command

Purpose

Step 1

[node](prt-dsl)[0/0]#[no] pvc-ip <vpi> <vci>

Creates a PVC and enters configuration

mode for this PVC. The "no"-variant

deletes the PVC configuration.

Mode: pvc ip

Step 2

[node](pvc)[vpi/vci]# encapsulation { llc | vc }

Sets the encapsulation to be used.

Optionally select either LLC

encapsulation or VC multiplexing for this

PVC. (default: llc)

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40 41

Commentaires sur ces manuels

Pas de commentaire